If you are tired of making earrings there is also a bracelet kit I can recommend. You begin by placing either a Pearl or Crystal on one of the eye pins. Use a flat nose pliers to bend the eye pin 90 degree and cut off the excess pin leaving approximately 3/16" left. Use round nose pliers to bend the eye pin into a loop and close tightly. Continue until all Pearls and Crystals are on eye pins with loops. Then connect your Pearl and Crystals using the jump ring. Be careful when opening the jump ring. Open by twisting to the side; do not stretch. As you connect the Pearls and Crystals, measure the length on your wrist for the right size. Finish off the bracelet by using a jump ring, and connecting the Spring Ring Clasp to one end, use a jump ring to connect on the opposite side when you feel the bracelet is long enough. A side note: You can use a needle to open the hole a bit and remove the coating of the pearl near the hole if you are having trouble putting the eye pins into your Pearls. There are enough materials to make a 9" bracelet, but you may have left over components if you decide to create a smaller bracelet. Now put on your earrings and bracelet and enjoy all the compliments.